Robert Rooks from Silverdale, WA United States
Relatively easy to install and set up in my application. I didn't use the included hearth plate because it sits on a brick hearth. Controls are simple and straightforward but it will be a little tricky to set the draft without a manometer. The fit of the two side panels and door could not be made perfect. The overall finish is very good. What I found very disappointing is that all the edges on the top are very sharp and unfinished (I cut my finger wiping the pellet door with a rag. Yes, cut through the rag). I realize the components are plasma cut, but they should be finished off by at least burnishing the edges.
My two cents.
Was this review helpful to you?
Browse for more products in the same category as this item: